DPMS AR Multi-Tool 5.56

This tool is very poor quality. I'm the kind of guy that gets by with cheap wally world & horrible fright tools, but the lack of QC on this rather simple tool is worse than the worst tool at the dollar store. The two pins that are used to torque the barrel nut were slightly off (not straight), and barely fit the nut. Once I approached 70 ft-lbs on my torque wrench one of the pins snapped off inside of my barrel nut. Luckily it did not damage my nut, but I had to buy a Wheeler multi tool at a local store to finish the job (which seemed much better). On top of this; the cut-out for adjusting muzzle devices is very large and had a lot of slop on a milspec A2 flash hider. I have used DPMS lower parts & other stuff without issue, but this tool they make is an absolute piece of crap. It now stays in my tool cabinet next to the hammers; because that's about all its good for.