Ok I bought the Romeo 1 Red Dot for this. Is there a way to to Co-witness the red-dot and iron sights. The notch on the Romeo1 & front sight seam a little low. I was also told that the suppressor sights would work? Not sure about that and no way to mount rear sight??? Any insight to this issue would be greatly appreciated.

Question

Randy I. · Answer

. I suggest that you contact Dawson precision as the are the BEST handgun sights experts around  Call Toll Free: (866) 300-1911 in fact they sell co-witness sights for the 320 https://dawsonprecision.com/sight-set-sig-p320-m17-co-witness-black-rear-and-fiber-optic-front-by-dawson-precision/

Paul F. · Answer

I've always been told you shouldn't slave the dot to the irons, meaning not to try adjust the elevation down to where it is a perfect cowitness with the front site, it busy up your field of view and makes acquiring the dot slower, plus because a reddot is single point of aim ots going to project out to ranges different then irons which are 2point aiming.

If your just talking about having your irons as a back up in case the electronics fail, then there is a notch in the rear of the romeo 1 that you use as your rear site and you should be able to see your front site post through this notch.

There are a couple youtube channels I watch for optics info and Aaron at sage dynamics is by far one of the best

Here's his video on the Romeo 1 
https://youtu.be/shdhVPc3Ivg

James G. · Answer

James, the easiest thing would be the suppressor height front sight. Cheers and stay safe!

Firearms

Also in Firearms

Ammo

Also in Ammo

Accessories

Also in Accessories

NFA | Class III

Also in NFA | Class III

Brands

Also in Brands

Specials

Also in Specials

Handguns

Rifles

Also in Rifles

Shotguns

Used Guns

NFA | Class III

Black Powder

Other Ways to Browse

Ask the Community