Ask the Community

They seem to be hit or miss for a little more money I would look seriously at the Henry https://www.budsgunshop.com/catalog/product_info.php/cPath/2084_36_107_980/products_id/96646/HENRY+H012+BIG+BOY+STEEL+44M%2FSPL

This particular rifle has some stock fit-up gaps between the butt-stock and the receiver. I loosened the screw a little, then bounced the butt on the floor, then tightened-up the screw. That took care of 75% of the gap. Also, on this particular unit, the front sight has had to be replaced with a lower one. With the rear sight adjusted fully up, it still shot low at 25 yards....at 75 or 100 it would not be on paper. Also, when they pressed the front sight in, they just positioned it flush with the right side of the ramp, but did not center it. That's just poor attention to detail. However, any factory rifle should be able to be brought to zero with the sights it came with. If I were not a very experienced shooter, I would have been frustrated that it could not be zeroed. The rifle functions well enough, but is not as smooth as my 1895. I am sure that with use, it will get better. I would rather Remington/Marlin put more effort in to fit and finish than have the stock checkering. The tri