Ask the Community

Hi Joel and welcome. I would check out the GeForce Arms accessories page ar: https://gfarmory.com/product-category/accessories/ ------------ Cheers and stay safe! It uses MLOK slots so you could add lights/lasers etc by using MLOK Picatinny Rail Sections - https://www.budsgunshop.com/search.php/q/picatinny+rail+section

Aftermarket support for this model with regards to parts to modify is almost nonexistent.

Hi Joel, there is not a lot out there for this no-frills GF3PD pump-action shotgun. The design is similar to the Remington 870, but there are some slight differences that prevent total parts or accessory interchangeability. The receiver is not drilled & tapped, so optics cannot be added. For a heat shield, you would need a generic shield that would most likely need to be fitted to the gun. You can also find a generic side saddle, but would need to drill for it, or you could get a shell holder that slides over the stock. There is a mag tube extension available >>> https://gfarmory.com/shop/magazine-tube-extension-with-barrel-tube-clamp/ As a side note, GF3PD is equipped with a fixed modified choke that offers some additional constriction that enables shot and 00 buck pellets to produce a tighter pattern at longer ranges. It is not recommended to run slugs through this barrel configuration.