BudsGunShop.com - 12GA stuck Dickinson/Titan Arms Pump 12GA

Question

12GA stuck Dickinson/Titan Arms Pump 12GA

Asked 07/13/2019 02:19 AM CT
by Siam C in Long Gun
I took apart my pump for cleaning and upon reassembly, I may have reassembled it incorrectly.
The barrel will not release and the pump will not disengage. I tried a variety of methods try and get it loose, but it will not come off. The barrel will move about half an inch while the pump will move less than that. Any ideas on how to get this back out?

3 Answers

You must log in to ask, or respond to a question

07/13/2019 11:12 AM CT
by James G - Lifetime Points: 92028

Siam, I would take it to a local gun smith or contact Dickinson Arms to see if they can walk you through resolving this or if they recommend Service at: https://dickinsonarms.com/contact-us

07/13/2019 03:19 AM CT
by Michael W - Lifetime Points: 4192

Siam, Do not worry about hurting it. Make sure fastener is off the magazine tube and take rubber maul and wood wedge and tap on barrel ring to loosen. Do not twist. Check your pump release tab and make sure that is not jammed up. Good luck.

Randy I · Accepted Answer · 2019-07-13T09:54:21-04:00

07/13/2019 09:54 AM CT
by Randy I - Lifetime Points: 29542
Chosen as Best Answer

contact Dickinson arms and ask for help 5140 Commerce Ave. Unit A&B
Moorpark, CA 93021 US
Phone : +1 (805) 978 – 8565
Fax : +1 (805) 978 – 8564
Email : info@dickinsonarms.com

BudsGunShop.com - 12GA stuck Dickinson/Titan Arms Pump 12GA

Unanswered Questions

Categories

12GA stuck Dickinson/Titan Arms Pump 12GA

3 Answers

Receive Money Saving Offers

Catalog

Information

Partners

SUBSCRIBE AND SAVE!

GET EVEN MORE!

THANK YOU!